Opel Calibra No Fear

[craigyboy]

Is there no chance you could get a better one from a breakers?

[Gargi]

very hard here in Serbia is difficult to find well preserved, and when you find a cost much

[Gargi]

Today bought a black floor mats, very good-looking, and are widely shame to cover the entire floor from edge to edge.
The pictures are bad, kill, but there you go.



Arrived and armrest.


Immediately and mounted on the console in the car, pictures standing between the seats tomorrow.

[Gargi]

[Gargi]

started after a long time to dye and install the plastic around the door handle

[Gargi]

Just to say that I took and white gauges.Picture with ads, on Tuesday should arrive.

[Gargi]

Small changes lead to real results!


The plan is to set up here with some tuning bracket

[Gargi]

Yesterday and today it worked and I'm pretty satisfied, even tomorrow when all blindfolded and place will be good.

So yesterday I'm from the old shelves with front passenger cut a piece of plastic, measure it and made gauge carrier that has the final as a handle ... and outlined the exact location and position and bearings


Today, I outlined the technical saws cut the bracket and made ​​grooves on the console that I barely made ​​because of the awkward position and can not drill with a drill bit just to approach but it worked.

Cropping beds .. and setting gauge



Cutting the groove mount bracket.



Bracket to bracket



job done

[Gargi]

Eve's factory










This wheel annoys me but I gotta be patient.

[Gargi]

and the dark variant

[Gargi]

I had to get a new lock, can not you, Father gatam morning work or not, and last winter I had problems.Now Solves trouble.

He took on the use of this madafaka air bag steering wheel while my FC arrives.

[Gargi]

Came the new stainless steel auspuff, of course, will have been changed by the end of my oval.

[EddeyDancer]

Is very good...

[Gargi]

One small detail: D

[Gargi]

Today, we are again done and over again exhaust system.
Mounted mid instantaneous or attached clamps, so it is easy to dismantle as necessary and rear stainless steel also on clamp.
The sound is reduced and pleasant to the ears, I'm tired of yelling and the chromed rear fine on gas.

I did not get to take pictures because we just did and watched it as soon as you're done.
Pictures will be because I have yet to assembled position endings are not exactly as I planned.
There.