F28 install

[Teejay]

Sent from my iPhone using Tapatalk

[Teejay]

'Ok, loosen, wiggle, tighten, repeat.........'


Sent from my iPhone using Tapatalk

[Allys Cally]

your welcome mate

as we say "we're not very good, but we have a laugh"

[v6 steve]

your welcome mate i just need to get the parts ordered now that we pinched off the drain for yours lol

[DanSE4]

Did anyone get any pics of the linkage?

I need to think about getting mine on next weekend.

[Teejay]

I will do you some pics fella, can get quite a good view from the n/s side of the engine bay


Sent from my iPhone using Tapatalk

[Teejay]

your welcome mate

as we say "we're not very good, but we have a laugh"

Sent from my iPhone using Tapatalk

[Teejay]

your welcome mate i just need to get the parts ordered now that we pinched off the drain for yours lol

Pm'd



Sent from my iPhone using Tapatalk

[MarkV6]

Did anyone get any pics of the linkage?

Here you go...


1 - The F25 bracket
2 - Linkage pin (Can't honestly remember if F25 F28 parts are same or not...)
3 - F28 Linkage rods
4 - This bolt goes into the threaded hole in the gearbox housing
5 - This bolt hole needs a smidge of modification as the threaded hole is in the bracket and the gearbox brackets holes don't line up

Another shot from the side

[v6 steve]

its the f28 linkage pin you need to use the f25 is too small

[DanSE4]

Here you go...

Awesome, thank you!!!